Yanmar parts catalogue / 23414-210000 GASKET, 21X1.0

23414-210000 GASKET, 21X1.0 — YANMAR

Yanmar 23414-210000 GASKET, 21X1.0 — position on the assembly diagram
3
The part position is highlighted in red on the diagram
  • Part number: 23414-210000
  • Manufacturer: Yanmar
  • Name: GASKET, 21X1.0
  • Weight: 30 g
  • Length: 6 mm
  • Width: 70 mm
  • Height: 30 mm

The diagram shows the assembly “Exhaust bend” of the Yanmar 6HAL2C-EP engine.

Check sellers for 23414-210000 on pFind.pro

Where part 23414-210000 is used

Yanmar part 23414-210000 is used in 94 engine models. Assemblies: exhaust bend, exhaust manifold, thermometer and 103 more.

Engine assemblyDiagram pos.QtyEngine modelsCatalogue notes
Exhaust bend 5 2
Exhaust bend 4 4
Thermometer(500DEG./620DEG.) 2 1
  • For T/C outlet
Thermometer(500DEG./620DEG.) 4 8
  • For exhaust each cylinder outlet
Exhaust bend 4 2
Thermometer(500DEG./620DEG.) 6 2
  • For T/C inlet
Cylinder water purge pipe 4 1
A/c drain pipe 4 2
Lub.oil motor pump 10 2
C.w.outlet pipe(a/c)(t/c fw.side) 6 2
Fuel overflow tank(mdo) 11 1
Cylinder block & liner 24 4
Lub.oil cooler 19 1
Fuel overflow tank 2 1
Depression cistern 10 1
C.w.outlet pipe(a/c)(t/c ofw.side) 6 2
Exh.connecting pipe(VTR354)(t/c ofw.side) 6 2
Exh.connecting pipe(VTR354)(t/c fw.side) 8 2
Lub.oil cooler 20 2
Fuel overflow tank 5 1
Thermometer (turbocharger) 1 2
Exhaust manifold 8 2
Exhaust bend 6 1
Fuel overflow tank(mdo) 11-1 2
  • Interchangeability: quantity in the assembly changed
F.o.overflow tank 2 1
Exhaust manifold 5 2
C.w.collecting pipe 9 1
Fuel overflow tank(mdo) 6 1
  • Interchangeability: part is discontinued
Fuel overflow tank 8-1 1
  • Interchangeability: new part number replaces the old one, not vice versa
  • Applies from: date 1990.10
L.o.pipe(generator bearing,sea water valve) 19 1
L.o.pipe(centrifugal strainer)(from exxxxx) 12 2
L.o.pipe(centrifugal strainer)(from exxxxx) 10 2
L.o.pipe(centrifugal strainer)(up to E00175) 7 2
Fuel overflow sump(MDO/7000SEC.OIL) 21 1
Exhaust bend(water tank spec) 7 1
Fuel overflow tank 8 1
Air duct b(a/c YPC190-CYLINDER)(t/c fw.side) 23 2
Lub.oil cooler 46 1
Thermometer(exhaust) 4 6
Lub.oil lines(cooler-cyl. bed) 18 1
Lub.oil lines(strainer-) 4 2
Exh.manifold 9 2
Exh.connecting pipe(VTR354)(t/c ofw.side) 15 2
Turbocharger 16 1
Air duct b(a/c heater YPC190-H75-CYL.)(t/c fw.side) 48 2
Air duct b(a/c heater YPC190-H75-CYL.)(t/c fw.side) 49 2
Lub.oil pump(clkw.) 54 1
C.w.collecting pipe 8 1
Air duct b(a/c heater YPC190-H75-CYL.)(t/c ofw.side) 51 4
Lub.oil lines(by-pass-cyl.bed) 7 1
Exhaust bend 4 1
Exhaust bend 5 4
Thermometer 11 1
  • Surge tank spec.
Exhaust manifold(b-bank) 27 8
Exhaust manifold 8 6
Exhaust bend 50 1
  • 1-LINE COOLING SYSTEM SPEC.
Lub.oil pipe(regulating valve inlet) 4 1
Cooling water pipe(collecting pipe outlet)(a-bank) 11 2
Lub.oil pump(clkw.) 50 1
Thermometer 6 2
  • For turbocharger outlet
Cooling water pipe(block inlet) 16 1
Cooling water pipe(block inlet) 5 1
Cooling water pipe(collecting pipe outlet)(b-bank) 11 2
Exhaust manifold(a-bank) 29 8
Exhaust bend 1 1
  • RADIATOR COOLING SPEC.
Exhaust bend(TD08/NEW) 8 1
  • 1,2-LINE COOLING SYSTEM SPEC.
C.w.outlet pipe(a/c heater)(t/c fw.side) 7 2
Exhaust manifold 31 2
  • Part superseded, not shown on the diagram
  • Interchangeability: additional part
  • Applies from: FROM 1ST
Lub.oil pipe(cooler-cly.bed) 22 1
Lub.oil pipe(by-pass-cyl.bed) 7 1
Exhaust bend(TD08/NEW) 20 1
  • RADIATOR COOLING SPEC.
Lub.oil pipe(strainer-) 4 2
Thermometer 1 1
L.o.pipe(cylinder in) 8 1
Fuel overflow tank(mdo) 18 1
  • Selection use parts.
Lub.oil pipe(f.i.pump oilling) 6 1
C.w.pipe(exh.manifold out) 8 1
Fuel sediment tank(100L) 34-1 2
Fuel overflow sump(MDO/7000SEC.OIL) 5 1
  • Selection use parts.
Fuel overflow sump(MDO/7000SEC.OIL) 9 2
Fuel overflow tank(mdo) 22 1
Fuel sediment tank(100L) 17 3
Lub. oil pipe(l.o.cooler-cylinder) 5 1
L.o.pipe(by-pass strainer) 31 2
Lub.oil pipe(f.i.pump oilling) 2 1
Exhaust bend 9 2
Thermo heater (lub.oil priming) 14 2
Thermo heater (non-l.o.priming) 14 2
  • Part superseded, not shown on the diagram
  • Interchangeability: part is discontinued
  • Applies from: date 1985.03
Cooling water heater 16 2
  • Part superseded, not shown on the diagram
  • Interchangeability: part is discontinued
  • Applies from: date 1985.02
Exhaust bend 1 1
Exhaust bend(radiator spec) 1 1
Lub.oil cooler 46 1
  • Interchangeability: additional part
  • Applies from: date 2011.05
Surge tank 10 1
Exhaust manifold 4 8
Exhaust manifold 37 2
Exhaust manifold 11 2
Battery switch & terminal box 39 2
  • Not illustrated.
Instrument panel(electric) 21 4
Exhaust manifold 15 8
C.w.collecting pipe 12 2
Thermometer 1 1
  • Surge tank spec.
Thermometer 15 2
Exhaust bend(8b) 2 2
  • Part superseded, not shown on the diagram
  • LEVEL CHANGED:2->1
Exhaust bend(6b) 3 2
  • Part superseded, not shown on the diagram
  • LEVEL CHANGED:2->1
Thermometer 15 1
Exh.bend(6b) 12 2
  • Part superseded, not shown on the diagram
  • Interchangeability: additional part
C.w.collecting pipe 13 2
Suction manifold 8 1
Exh.connecting pipe(TPL65)(t/c ofw.side) 6 2
Gas main pipe(main chamber) 11 1
  • Part superseded, not shown on the diagram
  • Interchangeability: part is discontinued
  • Applies from: date 2003.10
Temperature sensor 27 6
Thermometer 8 6
Thermometer 8 2
Thermometer 8 1
Cooling water collecting pipe 18 1
  • Part superseded, not shown on the diagram
  • Interchangeability: part is discontinued
  • Applies from: date 2003.09
Exhaust bend 14 1
Exh.connecting pipe(TPL65)(t/c fw.side) 6 2
Exhaust manifold 31 2
  • Part superseded, not shown on the diagram
  • Interchangeability: additional part
Lub.oil pipe(cooler-cylinder) 5 1
Cooling water concentric pipe 3 1
Exhaust manifold 26 9
Temperature sensor 32 1
Fuel overflow tank(mdo) 11-1 2
  • Interchangeability: quantity in the assembly changed
  • Applies from: Engine No 00138
Fuel overflow tank(mdo) 6 1
  • Interchangeability: part is discontinued
  • Applies from: Engine No 00138
Fuel overflow tank(mdo) 11-1 2
  • Interchangeability: quantity in the assembly changed
  • Applies from: Engine No 00137
Fuel overflow tank(mdo) 6 1
  • Interchangeability: part is discontinued
  • Applies from: Engine No 00137
Exhaust bend 7 1
Exh.manifold & connect.pipe,cover(t.fw.side) 22 2
Gear housing 2 1
  • Interchangeability: part is discontinued
  • Applies from: date 1988.09
Cooling water pipe(pump-cylinder) 17 1
Thermometer 10 2
Gear housing 15 1
  • NOT ILLUSTRATED.
Thermometer (exhaust) 1 6
C.w.pipe,pump outlet 5 1
Exhaust manifold 16 6
Exhaust manifold 42 2
Exh.bend(6b) 4 2
  • Part superseded, not shown on the diagram
  • Interchangeability: part is discontinued
Lub.oil cooler 13 1
Lub.oil cooler 16 1
Cylinder head 40 6
Thermometer 7 2
Exhaust manifold(water cooring) 8 2
Thermometer 5 2
  • Part superseded, not shown on the diagram
  • Interchangeability: part is discontinued
Exhaust flange 3 1
Exhaust bend 31 1
  • Part superseded, not shown on the diagram
  • Interchangeability: additional part
Cooling water pipe &thermostat 50 1
Cooling water pipe &thermostat 48 1
F.i.pump overflow pipe & sump 18 1
Cooling water pipe & thermostat(2-line discharge cooling spec) 52 1
Cooling water pipe & thermostat(1-line discharge cooling spec) 50 1
Exhaust manifold(radiator cooling spec.) 37 2
Lub.oil cooler 26 1
Thermometer 13 1
Thermometer 1-1 1
  • Interchangeability: old and new parts are interchangeable
  • Applies from: date 2012.05
Exhaust bend 7 1
  • 1,2-LINE COOLING SYSTEM SPEC.
Exhaust bend 31 1
  • Part superseded, not shown on the diagram
  • Interchangeability: additional part
  • Applies from: date 1991.03
Lub.oil cooler 29 1
  • Interchangeability: additional part
  • Applies from: Engine No 05459
Exhaust bend 3 1
Exhaust bend 25 1
  • RADIATOR COOLING SPEC.
Exhaust bend 37 1
  • 1-LINE COOLING SYSTEM SPEC.
Lub.oil pipe(pump-cooler) 17 1
Cooling water collecting pipe 12 2
Exhaust bend 3 2
Cooling water concentric pipe 12 1
C.w.collecting pipe 11 1
Exhaust manifold 21 8
Fo.chamber & fo.pipe(return pipe-pcv.-feed pump) 9 1
Fo.overflow sump & float switch 12 1
  • ADJUSTIVE USE.
Fo.overflow sump & float switch 19 1
Lub.oil press.regulating valve 20 1
Exhaust manifold 21 4
Fuel overflow switch(f.i.pipe) 14 1
Fuel pressure gauge pipe(f.o.chamber) 41 1
Cooling water pipe 13 2
Lub.oil pump 25 1
Turbocharger(TD13M/TD10L) 11 2
Turbocharger(RU110-1A) 6 1
Cw.press.gauge pipe & cyl.cw.purge pipe 8 1
Cw.outlet joint & throttle plate 12 2
Thermometer(500:C-620:c) 4 1
C.w.pipe(air cooler-l.o.cooler) 5 2
Cylinder block & liner,side cover 25 4
Thermometer(500:C-620:c) 6 2
Thermometer(500:C-620:c) 2 1
Fuel overflow pipe & overflow sump 44 1
Pulse absorb device 5 1
Exhaust manifold(radiator cooling spec.) 11 2
Exh.manifold & connect.pipe cover(t.ofw.side) 22 2
Lo.pipe(centrifugal strainer),centrifugal lo.strainer(GF200) 38 2
Cw.pipe(a/c.inlet & a/c.-lo.cooler,lo.c.outlet) 13 1
Lub.oil pump 45 1
Exh.connecting pipe & expansion joint,flange 6 1
Air duct(a/b),turbo.fw.side 37 2
Air duct(a/b),turbo.ofw.side 32 2
Fuel overflow sump(commonbed) 8 1

Other parts of the “Exhaust bend” assembly, Yanmar 6HAL2C-EP

Open the assembly diagram